Anyone have any experience with this reactor ?
In setting up, I let the CO2 tubing come off which the instructions say not to let happen as water can get into the membrane tubes.
I am concerned because my initial CO2 reading was 2.2 ppm (though I am not sure I read the pH and kH accurately).
Large air bubbles keep coming out of the reactor even though they are supposed to stop after 30 minutes. I am however using a high rate of CO2 injection as I read somewhere that wil give the plants a good start (no fish in yet).
Any way to tell if there is water in there or how to get it out if it is ?
Thanks !!
In setting up, I let the CO2 tubing come off which the instructions say not to let happen as water can get into the membrane tubes.
I am concerned because my initial CO2 reading was 2.2 ppm (though I am not sure I read the pH and kH accurately).
Large air bubbles keep coming out of the reactor even though they are supposed to stop after 30 minutes. I am however using a high rate of CO2 injection as I read somewhere that wil give the plants a good start (no fish in yet).
Any way to tell if there is water in there or how to get it out if it is ?
Thanks !!