As of now I don't have a lid on my 40 gallon breeder, so I've been adding a lot of water and siphoning out a lot of dust. I tried to make a plexiglass lid, but there's no middle support going across the tank so the pieces I cut sagged down under the weight of the condensation and were no good.
I'm looking at actual glass now, and I'm unsure of the best shape to go with. Does anyone have any suggestions about how to leave a hole for the filter and the other hoses/wires coming out of the back?
Can a glass cutter cut glass into a non rectangular shape? As in, can they cut a smaller rectangle out of the large glass rectangle so I can fit my filter through it?
I'm looking at actual glass now, and I'm unsure of the best shape to go with. Does anyone have any suggestions about how to leave a hole for the filter and the other hoses/wires coming out of the back?
Can a glass cutter cut glass into a non rectangular shape? As in, can they cut a smaller rectangle out of the large glass rectangle so I can fit my filter through it?